IBM N7800 Hardware And Service Manual page 74

13. At the boot environment prompt, enter the following command:
14. Select the Install new software first option from the displayed menu. This
15. Enter y when you see the following prompt:
16. Enter the path to the image.tgz file when you see the following prompt:
17. Restore the backup configuration on the target node by entering y and then
48
IBM System Storage: N7000 Series Hardware and Service Guide
If you...
Have DHCP enabled
Do not have DHCP enabled
netboot http://path_to_web-accessible_directory/netboot/kernel
menu option downloads and installs the new Data ONTAP image to the
CompactFlash card. If you are prompted to continue the procedure, enter y
when prompted.
This procedure is not supported for Non-Disruptive Upgrade on an HA pair.
Do you want to continue? [y|no] y
What is the URL for the package?
http://path_to_web-accessible_directory/image.tgz
entering the IP address of the server containing the varfs.tgz file when you
see the following screen:
Then...
Enter the following command:
ifconfig e0a -auto
Enter the following command:
ifconfig e0a -addr=filer_addr
-mask=netmask -gw=gateway -dns=dns_addr
-domain=dns_domain
filer_addr is the IP address of the storage
system.
netmask is the network mask of the storage
system.
gateway is the gateway for the storage
system.
dns_addr is the IP address of a name server
on your network.
dns_domain is the Domain Name System
(DNS) domain name. If you use this
optional parameter, you do not need a fully
qualified domain name in the netboot server
URL; you need only the server's host name.
Note: To netboot the node when your
system is running in 7-Mode, use an IP
address that is not the management IP
address for the target.
Note: Other parameters might be necessary
for your interface. For details, use the help
ifconfig command at the LOADER prompt.