IBM N7800 Hardware And Service Manual page 139

*> disk show -a
Local System ID: 118065481
DISK OWNER
------- -------------
0b.17 system-1 (118065481) Pool0 J8Y0TDZC
0a.17 system-1 (118065481) Pool0 J8Y09DXC
.
.
.
5. If the replacement node is in Maintenance mode (showing the *> prompt), exit
Maintenance mode by entering the following command:
halt
After you issue the command, wait until the system stops at the LOADER
prompt.
6. Enter the following command to boot the operating system:
boot_ontap
Restoring Fibre Channel configurations
Because the onboard Fibre Channel (FC) ports are not preconfigured, you must
restore any FC port configurations in your HA pair before you bring the node back
into service; otherwise, you might experience a disruption in service. Systems
without FC configurations can skip this procedure.
Before you begin
You must have the values of the FC port settings that you saved earlier.
Procedure
1. From the partner node, verify the values of the FC configuration on the
replacement node by entering the applicable command:
partner fcadmin config
2. Compare the default FC variable settings with the list you saved earlier.
If the FC variables are...
The same as you recorded earlier
POOL SERIAL NUMBER HOME
----- ------------- -------------
system-1 (118065481)
system-1 (118065481)
Then...
Proceed to the next step in this procedure.
Chapter 5. Replacing N7000 series system devices
113