Yamaha RX-V750 Owner's Manual page 35

7
Select a sound field program if desired.
Use PROGRAM (or press AMP to select the AMP
mode, then press one of the sound field program
buttons repeatedly) to select a sound field program.
See page 46 for details about sound field programs.
PROGRAM
or
Front panel
Note
When this unit detects Dolby Digital signals, the following
display appears for a few seconds. This shows how the signal
level is being corrected to become –27 dB.
DialNorm..+4dB
To listen with headphones (SILENT CINEMA)
The SILENT CINEMA mode allows you to enjoy multi-
channel music or movie sound, including Dolby Digital
and DTS surround, through ordinary headphones.
SILENT CINEMA activates automatically whenever you
connect headphones to the PHONES jack while listening
to CINEMA DSP or HiFi DSP sound field programs. The
"SILENT CINEMA" indicator lights up on the front panel
display. (If the sound field programs are off, you listen
with normal stereo reproduction.)
Note
This unit will not be set to the SILENT CINEMA mode when
MULTI CH INPUT is selected as the input source.
AMP
STEREO HALL JAZZ ROCK
1 2 3 4
MUSIC ENTERTAIN TV THTR MOVIE
5 6 7 8
q/DTS
PURE DIRECT NIGHT EX/ES
9 0 10 ENTER
Remote control
To adjust the tone
You can adjust the tonal quality
of your front left/right, center,
presence and subwoofer speakers
or headphones (when connected).
Press TONE CONTROL on the
front panel repeatedly to select
TREBLE or BASS, then rotate
PROGRAM to the right or left to
increase or decrease.
• Select TREBLE to adjust the
high frequency response.
• Select BASS to adjust the low
frequency response.
To cancel the tone control, press TONE CONTROL
repeatedly to select BYPASS.
y
You speaker and headphone adjustments are stored
independently.
Notes
• If you increase or decrease the high-frequency or the low-
frequency sound to an extreme level, the tonal quality of the
surround speakers may not match that of the front left/right and
center speakers.
• TONE CONTROL is not effective when the PURE DIRECT
(page 35) program is selected, or when MULTI CH INPUT is
selected.
• Speaker and headphone bass and treble adjustments are stored
independently.
To mute the sound
Press MUTE on the remote control.
"MUTE" blinks on the front panel
display.
To resume the audio output, press
MUTE again (or press VOL –/+).
"MUTE" disappears from the
display.
y
You can adjust the muting level (see page 59).
PLAYBACK
TONE CONTROL
PROGRAM
MUTE
31