Stihl FR 480 C Instruction Manual page 19

Mounting the Loop Handle without
Barrier Bar
8
7
4
5
1
N Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
N
Fit the clamp (6).
N Line up the holes.
N Fit the washers (7) on the screws
(8), and insert the screws in the
holes.
N Screw the square nuts (1) onto the
screws (8) as far as stop.
N Go to "Securing the Loop Handle".
FR 480 C
Securing the Loop Handle
8
7
4
3
6
1
N Secure the loop handle (4) about 20
cm (A) forward of the control
handle (9).
N Line up the loop handle.
N Tighten down the screws firmly –
lock the nuts if necessary.
The sleeve (10) must be between the
loop handle and the control handle.
Fitting the Throttle Cable
A
9
10
N
Go to "Adjusting the Throttle Cable".
A
1
2
A
1
2
Push the throttle cable (1) into the
two cable retainers (2) about 20 cm
(A) from either end of the shaft.
The whole length of the throttle
cable must run parallel to the
flexible shaft. Do not wrap the
throttle cable around the flexible
shaft.
English
17