Ending The Conference - Siemens optiPoint 410 User Manual

Operating the Telephone with the optiPoint display module
Step by Step
134

Ending the Conference

Changing back to single-line calls
Press the Hold symbol for one of the parties to place
this call on hold. The conference is ended. You can now:
• alternate between the parties;
• connect the other parties (Complete Transfer);
• re-enter the conference call;
• terminate the active call – you are connected to the
second party.
or End both calls using the display key
Press the End Conf. display key to terminate the con-
ference. You are disconnected from both parties.
or End both calls by hanging up
Prerequisite: "Allow Join in conference" was deactiva-
ted by the service personnel.
t
Replace the handset or press the loudspeaker key (in in
speakerphone mode). You are disconnected from both
parties.
or Connect the other parties using the display key
Prerequisite: "Allow Join in conference" was activated
by the service personnel.
Press the Join display key to connect the other parties.
or Connect the other parties by hanging up
Prerequisite: "Allow Join in conference" was activated
by the service personnel.
t
Replace the handset or press the loudspeaker key (in in
speakerphone mode). The other two parties are con-
nected. You can start a new call.