Epson LX-300+II Reference Manual page 97

Switching between the cut-sheet feeder and the push tractor
does not work properly
The desired paper type does not load.
Cause
The paper release lever
may not be in the proper
position.
Using the pull tractor with the push tractor, continuous paper
does not feed properly
Paper is feeding crooked or jams.
Cause
The pull tractor and push
tractor sprockets are not
aligned correctly.
The paper may have too
much slack.
The paper may be caught
on the edge guides.
What to do
Pull the lever forward to load
continuous paper or push the lever back
to load single sheets.
What to do
When using both tractors, make sure
that the sprockets on both are positioned
evenly.
Adjust the position of the sprockets to
take up any slack along the width of the
paper. Remove slack lengthwise by
rotating the paper feed knob.
Make sure that the paper guide is
installed over the paper and that the
edge guides are positioned correctly.
Maintenance and Troubleshooting
97