Konica Minolta bizhub C20 Reference Manual page 502

The Network - SNMP window allows you to configure the following items:
Item
SNMP
SNMP v1/
v2c/(IP)
478
Description
SNMP If Enable is selected, SNMP is enabled.
Choices: Enable, Disable
Default: Enable
Configuration Menu Equivalent:
UTILITY - ADMIN. MANAGEMENT -
NETWORK SETTING - SNMP
SNMP v1/ If Enable is selected, SNMP v1/v2c(IP) is enabled.
v2c(IP)
Choices: Enable, Disable
Default: Enable
SNMP If Enable is selected, SNMP v3(IP) is enabled.
v3(IP)
Choices: Enable, Disable
Default: Enable
SNMP If Enable is selected, SNMP v1(IPX) is enabled.
v1(IPX)
Choices: Enable, Disable
Default: Enable
UDP Port Specifies the UDP port number.
Range: 1 - 65535
Default: 161
Read Specifies the community name to be used for scan-
Commu- ning.
nity Name
Range: Up to 15 characters
Default: public
Write If Enable is selected, Write is enabled.
Choices: Enable, Disable
Default: Enable
Write Specifies the community name to be used for read-
Commu- ing and writing.
nity Name
Range: Up to 15 characters
Default: private
In order for this parameter to be available,
NetWare Print in the Network - NetWare
page must be set to Enable.
The numbers 427 and 500 cannot be
specified.
Configuring the Printer