Kyocera ECOSYS P5021cdn Operation Manual page 181

Troubleshooting > Troubleshooting
Message
Cannot connect server
Press Go
Cannot connect to
Authentication Server
Cannot connect.
Cannot recognize.
Cannot start this job
Press Go
Cannot use this
function.
Cassette # not loaded
Check cassette #
Close rear cover #
Close right cover.
Connection limit
exceeded.
D
Message
Device busy
Duplex disabled
Press GO
Checkpoints
―
―
―
―
―
―
―
―
―
Is there any cover which is open?
Is there any cover which is open?
Are the toner containers installed
correctly? Is a toner container out of
place?
―
Checkpoints
―
Did you select a paper size/type
that cannot be duplex printed?
8-13
Corrective Actions
The job is canceled. Select [Go] key.
Check the connection status with
the server.
Set machine time to match the
server's time.
Check the connection status with
the server.
This appears when the Wi-Fi or Wi-
Fi Direct connection did not
complete. Check the settings, and
check the signal conditions.
Make sure your ID card has been
registered.
You cannot use the specified box.
Job is canceled. Select the [GO]
key.
This message is displayed when a
user tries to use the restricted
function.
The corresponding paper cassette
is not installed. Install the cassette.
Open and then close the indicated
cassette.
Close the cover indicated on the
screen.
Close the cover indicated on the
screen.
Make sure all 4 colors of toner
containers are installed correctly,
and close the right cover.
Cancel a connection to a portable
device that is not being used, or set
the machine's auto disconnect time
to break portable device
connections.
Corrective Actions
This message is displayed when
Remove Device was selected while
a USB memory was being used.
The previous screen is displayed
again 1 or 2 seconds.
Select [Menu] to select the
available paper. Select the [GO] key
to print without using Duplex
function.
Reference
Page
―
page 2-15
―
page 6-10
―
―
―
―
―
―
―
page 8-4
―
Reference
Page
―
―