Subaru 2010 Tribeca Owner's Manual page 271

Period of
time multi-
Gear
function
position
button is
pressed
Briefly
Rear view display
ON/OFF*
R (reverse)
More than
Help lines indica-
3 seconds
tion ON/OFF
Except Briefly
Auto-dimming
R (reverse)
function ON/OFF*
3 to 6
Electronic com-
seconds
pass display ON/
OFF
6 to 9
Enter the com-
seconds
pass zone setting
mode
9 to 12
Enter the com-
seconds
pass calibration
mode
*: The setting returns to "ON" as a default
setting every time the ignition switch is turned to
the "ON" position.
! Rear view image display
When the ignition switch is "ON" and the
select lever is set to "R", the rear view
camera automatically displays the rear
view image behind the vehicle on the
inside mirror.
Also, the following help lines are indicated
as a guide to help you realize the actual
distance from the display.
Function
displayed
1) Vehicle width line (oblique vertical line)
2) Approx. 10 feet (3 m) from the bumper
(green horizontal line)
3) Approx. 6.5 feet (2 m) from the bumper
(green horizontal line)
4) Approx. 3 feet (1 m) from the bumper
(yellow horizontal line)
5) Approx. 1.5 feet (0.5 m) from the bumper
(red horizontal line)
These help lines are removable. To
remove the help lines, perform the follow-
ing procedure.
1. Display the rear view image on the
mirror.
2. Press the multifunction button for more
than 3 seconds to remove the helplines.
To display the help lines, press the multi-
function button for more than 3 seconds.
Instruments and controls
For precautions about the rear view
camera and the rear view image, refer to
"Rear view camera" F6-22.
! Auto-dimming function
The auto-dimming function is an anti-glare
capability which automatically reduces
glare coming from headlights of vehicles
behind you.
By briefly pressing the multifunction but-
ton, the auto-dimming function is toggled
on or off. When the auto-dimming function
is on, the auto dimming indicator light
(green) will illuminate.
Even with the mirror in anti-glare mode,
the mirror surface turns bright if the
transmission is shifted into reverse. This
is to ensure good rearward visibility during
reversing.
– CONTINUED –
3-39