Speedometer - Subaru 2008 Impreza Owner's Manual

3-10
Instruments and controls
& Canceling the function for
meter/gauge needle move-
ment upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Turn the ignition switch to the "LOCK" or
"Acc" position.
Press the trip knob to show "
on the odometer and trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
*: " " or "
the ignition switch is in the "ON" posi-
tion.
To change the current setting, press the
trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
Your vehicle's initial movement
setting of the meter/gauge needles
has been set for activation "
time of shipment from the factory.
It is not possible to cancel the initial
movement setting of the meter/gauge
" or " "
needles when the ignition switch is in
the "ON" position. Cancel the setting
when the ignition switch is in the
"LOCK" or "Acc" position.
" cannot be displayed when
" at the
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer/Trip meter
1) Trip knob
This meter displays the odometer and two
trip meters when the ignition switch is in
the "LOCK", "Acc" or "ON" position.
If you press the trip knob when the ignition
switch is in the "LOCK" position, the
odometer/trip meter will light up. It is
possible to switch the indications while
the odometer/trip meter is lit up. If you do
not press the trip knob within 10 seconds
of illumination of the odometer/trip meter,
the odometer/trip meter will go off.