Ipod - Yamaha RX-V765 Owner's Manual

Troubleshooting
Problem
External components
cannot be controlled
by the remote control.

iPod™

Note
• In case of a transmission error without a status message appearing on the front panel display and on the OSD, check the connection of your iPod
(see page 19).
Problem
Loading...
Connect error
Unknown iPod
iPod Connected
Disconnected
Unable to play
62
En
Cause
The remote control code is not correctly
set.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
Cause
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
Your iPod is properly placed in the
Yamaha iPod universal dock.
Your iPod is removed from the Yamaha
iPod universal dock.
This unit cannot play back the songs
currently stored on your iPod.
Remedy
Set the remote control code correctly using "List of
remote control codes" at the end of this manual.
Try setting another code of the same manufacturer
using "List of remote control codes" at the end of this
manual.
If this unit does not work when you press
do the following.
When the key does not work during DVD disc menu
operation: press the eInput selection keys on
the remote control again.
When the key does not work during OPTION menu/
SETUP menu operation: press the key applicable for
the current menu operation again.
Remedy
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK jack of this unit.
Remove your iPod in the Yamaha iPod universal dock
and then place it back in the dock.
Connect an iPod supported by this unit.
Check that the songs currently stored on your iPod
are playable.
See
page
53
53
k Cursor,
—
See
page
19
19
—
—