Table of Contents
Advertisement
Do not connect devices that cannot be used with commercial power
supply.
When the unit's power switch is turned ON and an error occurs with the connected device, by-
●
pass operation is performed and commercial power supply is supplied as is to the connected
devices.
When installing the unit on a rack, place it on the lower shelf.
Injury may result if the unit falls.
●
Make sure to use the mounting screws included with the brackets.
Mounting screws other than those included may not be strong enough to support the unit, caus-
●
ing it to fall.
If you attach the case using long screws other than those included with the product, you may
●
damage the internal parts of the unit.
When using the unit in the 100V output mode, check that the output
voltage is set to 100V, and then turn ON the power switch.
Connecting a 100V device to the unit while outputting in the 200V mode may cause a failure of
●
the device or a fire.
The output voltage can be set with "Settings" - "In/Out Settings" - "Output Voltage" in the menu
●
on the LCD.
2002
BU
Caution
(for installation and connection)
3002
RWLG/BU
RWLG/BU
5002
RWLG
2
7
Advertisement
Table of Contents
