English
9
10
Use the spring (9) from the parts kit
N
supplied with the machine.
Place the spring (9) in the lower
N
clamp molding (10).
A
1
2
Position the clamp moldings (1) with
N
handlebar (2) on the handle
support (11).
16
2
Raise the grip of the wing screw (7)
N
to the upright position.
Turn the wing screw
N
counterclockwise as far as stop.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Adjust the handlebar (2) so that
N
distance A is no more than 15 cm.
Line up the handlebar at a right
N
angle to the drive tube.
11
Turn the wing screw clockwise as
N
far as stop.
7
N
FS 260: Fitting the Throttle Cable
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
N
Fold the grip of the wing screw down
so that it is flush.
NOTICE
12
13
13
12
Attach the throttle cable (12) to the
retainer (13).
FS 260 C, FS 360 C