Camera/Computer Communications - Kodak EasyShare C643 User Manual

If...
Ready light glows
steady red.
Ready light glows
steady green.

Camera/computer communications

If...
The computer does
not communicate
with the camera.
Cannot transfer
pictures.
(The Add New
Hardware Wizard
cannot locate
drivers.)
www.kodak.com/go/support
Downloaded From camera-usermanual.com Kodak Manuals
Try one or more of the following
I
Transfer pictures to the computer
camera (page 11), switch image storage locations
a card with available memory
I
Wait. Resume picture taking when the light turns green.
I
Change the image storage location to internal memory
use a different card.
I
Camera is operating normally.
Try one or more of the following
I
Visit www.kodak.com/go/c643support
www.kodak.com/go/c603support.
I
Turn on the camera
I
Install new batteries
I
See the Power Management section of the laptop user's guide to
disable this feature.
I
Connect cable to camera and computer port
I
Install the software
I
Disconnect the USB cable. Close all open applications. Re-install the
software (page 12).
I
Disconnect camera from the computer. Close all software applications,
reconnect camera.
I
Disconnect USB cable. (If using camera dock or printer dock,
disconnect cable and remove camera from dock). Close all open
applications. Re-install the software
I
Disconnect the USB cable. Close all open applications. Re-install the
software (page 12).
(page 13), delete pictures from the
(page 3).
or
(page 2).
(page 1) or charge rechargeable batteries.
(page 12).
(page
Troubleshooting
(page 27), or insert
(page 27), or
(page 13).
12).
43