Table of Contents
Advertisement
312
Installing the Video Interface (VIF4)
NTSC, PAL, SECAM
Installing the Video Interface (VIF4)
You can install a Korg VIF4 Video Interface into your Pa800.
This interface will let you connect a video monitor, TV set, video
recorder or video projector, to read lyrics on an external device.
The card can be installed by the user. Korg is not responsible for
any damage or injury caused by incorrect installation of this
card by unauthorized personnel.
NTSC, PAL, SECAM
The VIF4 is compatible with the NTSC, PAL and SECAM TV
standard. When connecting a SECAM-compliant TV set, select
the PAL standard. However, in this latter case, the image will be
shown in black and white.
Precautions
• Installation of the card is done at the user's own risk. Korg will
assume no responsibility for any damage or injury resulting
from its improper installation or use.
• Be sure to disconnect the instrument from the AC plug, before
opening it.
• To prevent your body's static electricity from damaging the
board's components, touch an unpainted metallic component
before proceeding with the installation.
Installation
For installation, you will need a cross-point screwdriver and a pair
of pliers (not supplied).
1.
On the back of the instrument, unscrew the two screws (a)
and extract the cover (b), to gain access to the video slot.
2.
Fully remove the cover (b) by unfasteing the ground cable
(c). Be very careful not to let the ground cable (c) and the
attached power cable (d) fall inside the instrument.
3.
Extract the video card (e) from its package, being careful
not to touch any component on its surface with your fin-
gers. Connect the ground cable (c) and the power cable (d)
to the corresponding connectors on the video card, as
shown in the illustration.
4.
Slide the video card (e) inside the slot, and attach it to the
instrument using the two previously removed screws (a).
Advertisement
Table of Contents
