Specific Safety Rules - Porter-Cable PC75TRS Instruction Manual

b) Do not use the power tool if the switch does not turn it on and off. Any power
tool that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the
power tools. Such preventive safety measures reduce the risk of starting the power
power tool before making any adjustments, changing accessories, or storing
tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
Power tools are dangerous in the hands of untrained users.
unfamiliar with the power tool or these instructions to operate the power tool.
e) Maintain power tools. Check for misalignment or binding of moving parts,
operation. If damaged, have the power tool repaired before use. Many
breakage of parts and any other condition that may affect the power tool's
accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these
instructions and in the manner intended for the particular type of power tool,
Use of the power tool for operations different from those intended could result in a
taking into account the working conditions and the work to be performed.
hazardous situation.
5) Service
replacement parts. This will ensure that the safety of the power tool is maintained.
a) Have your power tool serviced by a qualified repair person using only identical
• Hold power tool by insulated gripping surfaces, when performing an operation

Specific Safety Rules

where the cutting accessory may contact hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
• Use clamps or another practical way to secure and support the work piece to a
stable platform. Holding the work by hand or against your body leaves it unstable and
may lead to loss of control.
• Hold saw firmly with both hands for all cutting operations. During cutting operations,
the blade may suddenly bind in the work and may cause the saw to kickback towards the
operator.
• Keep hands away from cutting area. Never reach underneath the material for any
reason. Hold front of saw by grasping the contoured gripping area. Do not insert fingers
or thumb into the vicinity of the reciprocating blade and blade clamp. Do not stabilize the
saw by gripping the shoe.
• Keep blades sharp. Dull blades may cause the saw to swerve or stall under pressure.
• Use extra caution when cutting overhead and pay particular attention to overhead
wires, gas or water lines, which may be hidden from view. Anticipate the path of falling
branches and debris ahead of time.
• When cutting pipe or conduit ensure that they are free from water, electrical wiring, etc.
• Do not touch the workpiece or the blade immediately after operating the tool.
They can become very hot.
ALWAYS use safety glasses. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR
WARNING:
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities contains chemicals known to the State of
WARNING:
California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
3