Porter-Cable PC75TRS Instruction Manual page 7

NOTE: Blade can be installed with the teeth up to assist in flush-to cutting.
TO REMOVE BLADE FROM SAW
making any adjustments or removing or installing attachments or accessories.
WARNING:
with the blade may result in personal injury.
WARNING:
1. Rotate blade clamp collar to release position.
2. Remove blade.
ORBITAL ACTION SELECTOR - (FIGURE
4 PC85TRSO ONLY)
The PC85TRSO has dual blade motion:
straight reciprocating motion or orbital motion.
Straight reciprocating motion is used for all
metal cutting operations and for wood cutting
applications where finish is more important
than speed. To set the saw for straight reciprocating motion, turn the selector to the
position marked
Orbital motion is used for fast cutting of wood. To set the saw for orbital action, turn the
selector to the position marked
ADJUSTABLE SHOE - (FIGURE 5 PC85TRSO ONLY)
past the shoe and the workpiece during the cut. Increased risk of personal injury, as well
WARNING:
as damage to the shoe and workpiece may result.
disconnect tool from power source before
WARNING:
making any adjustments or removing or
installing attachments or accessories.
The shoe will adjust to limit the depth of cut.
Push the button (shown in Figure 5) on the
hand grip and slide the shoe out to the
desired depth and release the button.
CUT HAZARD. To prevent
loss of control, never use tool without shoe.
CAUTION:
RISK OF PERSONAL INJURY AND PROPERTY DAMAGE. Ensure the
shoe is locked into position before using tool.
CAUTION:
ADJUSTABLE SHOE - (FIGURE 6 PC75TRS ONLY)
breakage may occur if the blade does not
WARNING:
extend past the shoe and the workpiece
during the cut. Increased risk of personal
injury, as well as damage to the shoe and
workpiece may result.
disconnect tool from power source before
WARNING:
making any adjustments or removing or
installing attachments or accessories.
The shoe will adjust to limit the depth of cut.
Using a M4 (5/32 in.) hex wrench (not
supplied), loosen the screws (Figure 6) and
slide the shoe out to the desired depth then
retighten screws securely.
CUT HAZARD. To prevent
loss of control, never use tool without shoe.
CAUTION:
CUT HAZARD. Turn off and disconnect tool from power source before
Burn hazard. Do not touch the blade immediately after use. Contact
CUT HAZARD. Blade breakage may occur if the blade does not extend
CUT HAZARD. Turn off and
CUT HAZARD. Blade
CUT HAZARD. Turn off and
4
5
6
7