Table of Contents
Advertisement
Parameter
Area
Record
Record Delay
Relay out
Alarm Delay
Send Email
Audio linkage
Flash linkage
PTZ
Snapshot
See Figure 4-32.
Function
Here you can set motion detection region and its sensitivity and area. (The
higher the sensitivity is, the easier to trigger motion detect; the smaller the
area, the easier to trigger motion detect.) The default covers all regions.
You must click on save before enabling your setup.
Check it and so when alarm occurs, system will auto record. You shall set
record period in Storage>Schedule and select auto record in record control
interface.
System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
Enable alarm activation function. You need to select alarm output port so
that system can activate corresponding alarm device when alarm occurs.
System can delay the alarm output for specified time after alarm ended. The
value ranges from 10s to 300s.
If you enabled this function, System can send out email to alert you when
alarm occurs and ends. User can set email address in Network>SMTP.
Check it and the system will play alarm audio file when alarm occurs. Users
can set the recorded or uploaded audio file in "camera setting ＞ audio ＞
alarm audio".
Check it and the flash will be on when alarm occurs, and the flash will
be off until the end of alarm after corresponding delay.
Here you can set PTZ movement when alarm occurs. Such as go to
preset x when there is an alarm.
The event type includes: preset, tour and pattern.
You need to check the box here so that system can backup motion detection
snapshot file. You shall set snapshot period in Storage>Schedule.
52
Advertisement
Table of Contents
