Table of Contents
Advertisement
Please refer to the following sheet for detailed information.
Parameter
Sub Stream Enable
Code-Stream Type
Encode mode
Resolution
Frame Rate (FPS)
Bit Rate Type
Recommended Bit
Figure 4-7
Function
Please check the box here to enable extra stream
function.
This function is enabled by default.
ACF means using different fps to record.
There are two options: VBR and CBR.
Please note you can set video quality in VBR mode.
Note:
WEB interfaces don't support motion detect and alarm
code stream setting.
There are five options: H.264 (main profile standard,
H.264H (high profile standard), H.264B (Baseline
Profile), H.265 (main profile standard) and MJPG
encode.
The H.264, H.264H both are H264 bit stream.
H.264 is the Main Profile encode and you need to
enable the sub stream function in your camera and
set the resolution as CIF. Then you can monitor via
the Blackberry cell phone.
The H.265 is the main profile encode mode.
MJPEG: In this encode mode, the video needs to
large bit stream to guarantee the video definition.
You can use the max bit stream value in the
recommend bit to get the better video output effect.
There are multiple resolutions. You can select from the
dropdown list.
For each resolution, the recommended bit stream value
is different.
Note: When video is under rotating status, you cannot
set resolution higher than 1080P (excluding 1080P).
PAL: 1～25f/s，1-50f/s NTSC: 1～30f/s or 1~60f/s.
The frame rate may vary due to different resolutions.
There are two options: VBR and CBR.
Please note, you can set video quality in VBR mode.
Under MJPEG mode, only CBR is available.
Recommended bit rate value according to the resolution
and frame rate you have set.
29
Advertisement
Table of Contents
