Scanner Enhance Option; Accessory Check; Installation (Application Merge) - Ricoh D129 Service Manual

Printer and P/S Options (Basic Models)
12. Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port [A].
13. Connect the other end of the Ethernet interface cable to a network connection device such as
a hub.
14. Connect the machine's power cord and turn the main power switch on.
15. Enable the NIB and/or USB function.

To enable the NIB function, enter the SP mode and set SP5985-001 (On Board NIC) to
"1" (Enable).

To enable the USB function, enter the SP mode and set SP5985-002 (On Board USB) to
"1" (Enable).

1.2.4 SCANNER ENHANCE OPTION

Accessory Check

Refer to the "Common Accessory Table" in this chapter.

Installation (Application Merge)

The installation of the scanner enhance option are done with SP5873-001 (Application Move).

If you are going to update the RPCS unit with both the printer and scanner enhance
options, the order of execution is not important.
1. Turn off the copier.
2. Remove the cover (
3. Confirm that the Printer Unit SD card is in SD card Slot 1 (Upper Slot).
4. Put the option SD Card (Scanner Enhance Option) in SD card Slot 2 (Lower Slot).
5. Open the front door.
6. Turn the copier on.
7. Go into the SP mode and select SP5873-001.
8. Touch "Execute".
9. Read the instructions on the display and touch "Execute" to start.
10. When the display tells you copying is completed, touch "Exit", then turn the copier off.
D641
x1).
12 SM