Stihl MS 200 T Instruction Manual page 20

English
Setting the Master Control lever
To move the Master Control lever from
the normal run position (F) to cold start
(n), press down the throttle trigger
lockout and squeeze the throttle trigger
at the same time.
To select warm start (n), move the
Master Control lever to cold start (l)
first, then push it into the warm start
position (n).
The change to warm start (n) is
possible only from the cold start
position (l).
The Master Control lever moves from
warm start (n) to the normal run
position (F) as soon as the throttle trigger
is squeezed.
To switch off the engine, move the
Master Control lever to Stop 0.
18
Holding the saw
N Place your saw on the ground.
Make sure you have a firm footing –
check that the chain is not touching
any object or the ground.
N Hold the saw firmly with your right
hand on the top handle.
N Rest your right knee on the
carburetor box cover.
Start the engine.
Bystanders must be well clear of
the general work area of the saw.
Observe safety precautions.
2
4
3
N Push the hand guard (1) forward –
the chain is locked.
N Press down the throttle trigger
lockout (2) and pull the throttle
trigger (3) at the same time. Hold
both levers in that position and set
Master Control lever (4) to:
Choke shutter closed (l)
– If the engine is cold (also use this
position if the engine stopped when
you opened the throttle after
starting)
Starting throttle position (n)
– If the engine is warm, i.e. if it has
been running for about one minute.
1
MS 200 T