Operating The Maxi Display Using The Control Button - Raymarine T210 User Manual

Maxi Display
To clear Page Hiding and return to all pages visible:
Press and hold
Press
Press
number of pages hidden
4.4 Operating the Maxi Display using the control
button
The Maxi Display is designed to be operated and configured using a
Tacktick Remote Display; however for emergency use, there is a limited
control function available via the single control button.
To switch on the system press the button for two seconds.
The display starts up in Chapter mode; quick presses of the button scroll
through the available chapters, the data page most recently accessed in
each chapter is shown.
To change the page, press the button for two seconds; the display
changes to Page mode (the legend PAGE MODE is shown briefly).
Quick presses of the button scroll through the available pages in the
chapter.
To return to Chapter mode press the button for two seconds again
(the legend CHAPTR MODE is briefly displayed).
To switch off the system press the button for four seconds
Lighting any press of the button will switch on backlighting for the
display (this will be auto dimmed in daylight).
Note: it is not possible to configure the Maxi Display using its control
button. This must be carried out using a Tacktick Remote Display.
16
to enter set up
to reach the OPTIONS chapter
to reach the Pages Hidden page; the display shows the total
Press to return to all pages visible
Press and hold
Note: the factory reset function in setup will return page
hiding to the default setting.
to exit setup.
www.tacktick.com