Raymarine T210 User Manual page 30

Maxi Display
Power Save Alarm sounds
There has been no significant data activity on the network. The alarm
sounds to indicate that the display system will turn itself off. To continue
using the system press any button to cancel the alarm.
Lost Network Alarm sounds
This indicates that one or more displays have lost communication with
the Master. Either there is a problem with the Master display or the
displays in question have been moved out of effective range. The
displays will switch off after sounding the alarm to save power.
Note: The "Master" display is the display used to power up the entire
system. This may be different each time the system is used. If you are
uncertain which display is the master, switch off the system and switch on
again. The display which you switched on is now the Master.
A single display flashes the battery symbol and then switches off
The battery level is low on the particular display affected. Connect to a 9
to 30V DC power source or leave in bright sunlight for 12 hours minimum
to recharge the display's internal battery. If the particular display is the
system Master then the other displays will sound the "Lost Network"
alarm. To continue using the rest of the system power down and restart
the system from another display.
Low Battery Alarm sounds
The power level is low in the Hull Transmitter, Wireless (NMEA) Interface
or Wind Transmitter. Enter Setup mode on the Remote Display and scroll
to the Health Chapter. Check the battery levels of the Transmitters and
Interface Box. The battery level icon should show 1, 2 or 3 bars to ensure
correct operation. Connect the Hull Transmitter or Wireless (NMEA)
Interface to a 9 to 30V DC power source for 12 hours minimum to
recharge the internal battery. Leave the Wind Transmitter in bright
sunlight for 12 hours minimum to recharge its internal battery.
Data is shown as dashes
The information is not being transmitted to the displays. There may be
lost communication between the Wind Transmitter or Hull Transmitter
and the displays. Enter Setup mode on the Remote Display and scroll to
the Health Chapter. Check the signal levels of the Hull and Wind
Transmitters. The signal level should show a value greater than 3 to
ensure correct operation.
28 www.tacktick.com