Table of Contents
Advertisement
Chapter 2 Getting Started — Installing/removing the projector
f Allowing for attaching the adapter cover to be performed in Step 17), mount the adapter to the track system
using the rough dimension shown in the figure.
16) Secure the adapter to the track system.
f With the adapter inserted into the opening of the track system, hold the adapter body and turn it 90°
clockwise.
f Confirm that the hook top of the adapter is housed in the opening of the track system.
Hook
17) Attach the adapter cover.
f While aligning the protrusion at the lower center of the adapter cover to the depression on the power supply
unit (i), push both tabs at the upper side of the adapter cover into the notches of the power supply unit until
they click (ii). Be careful not to get the string caught in the adapter cover.
Power supply unit
(ii)
Notch
38 - ENGLISH
Adapter body
Tabs
Adapter cover
(i)
53 mm (2-3/32") -
57 mm (2-1/4")
Track system
Hook
Adapter body
Illustration after the adapter cover
has been attached
Hook top
Advertisement
Table of Contents
