Panasonic PT-JX200HBU Operating Instrucctions page 37

Chapter 2 Getting Started — Installing/removing the projector
ii) Secure the bracket of the safety wire with commercially available tapping screw (head diameter: Φ3.8 mm
(5/32")) to the sturdy ceiling with reinforcing material as shown in the figure below.
Ceiling foundation
(Field edge or
reinforcing material)
Ceiling material
(Gypsum board, etc.)
14) Align the orientation of the adapter to the track system.
f While rotating the adapter body (i), hold it up (ii) and align the side with the hook of the adapter to the side
with the groove of the track system.
WARNING
Attach the adapter in the right direction to the track system.
Using the projector with the adapter attached in the wrong direction will result in fire or electric shocks.
15) Mount the adapter to the track system.
f Insert the adapter into the opening of the track system.
f Insert the adapter into the opening of the track system in the right direction. Inserting it in the wrong
direction may damage the track system or the adapter when securing the adapter to the track system in
Step 16).
f The track mount parts A/B and the adapter of the projector cannot be mounted to the position of the tapping
screw fixing the track system to the ceiling or beam.
Ceiling
Track system
Within 600 mm
Tapping screw
Pole
Cables from main unit
to power supply unit
(i)
Safety wire
Shaft holder
Track system
Groove
(ii)
(i)
Hook
Adapter body
(ii)
Bracket
Ceiling hole
Bracket
Tapping screw
ENGLISH - 37