Table of Contents
Advertisement
Chapter 2 Getting Started — Installing/removing the projector
f Confirm that both hook clasps A/B are securely housed inside the track system.
(i)
Lever A
WARNING
When mounting to the track system, turn both levers A/B all the way until they hit the end.
Inadequate mounting to the track system may result in the projector falling off.
11) Fix the lever A locking screw.
f Tighten the lever A locking screw (M3) using a Phillips screwdriver (ISO No. 2, diameter: 6 mm (1/4")), and
fix to the lever plate A.
12) Fix the lever B locking screw.
f Tighten the lever B locking screw (M3) using a Phillips screwdriver (ISO No. 2, diameter: 6 mm (1/4")), and
fix to the lever plate B.
Lever plate B
Lever B
Lever B locking screw
13) Attach the safety wire.
i) Pull one end of the safety wire around the shaft holder and put through the loop as shown in the figure below.
36 - ENGLISH
Lever plate A
Lever A
Cross section
(ii)
Lever B
Cross section
Lever A locking screw
Lever plate B
Lever B
Lever B locking screw
Advertisement
Table of Contents
