Connections - Panasonic TH-37PH10UK Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
(Example: TH-42PH10UK)
Speakers (Optional accessories)
SPEAKERS
Terminals (R)
– AC cord fi xing
Note:
Make sure that the AC cord is locked on both the left and right sides.
– Cable fi xing bands
Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Notes:
• At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
• TH-37PH10UK has two slots only.
AC cord connection (see page 13)
Plug the AC cord into the display unit.
Plug the AC cord until it clicks.
To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
R L R L
AUDIO AUDIO
S VIDEO
B AV IN A
SLOT2
Dual Video Terminals COMPONENT/RGB IN and
(equivalent of BNC Audio IN Terminals (equivalent
Dual Video Terminal of BNC Component Video
Board (TY-FB9BD)) Terminal Board (TY-42TM6A))
(see page 12) (see page 12)
SPEAKERS
Terminals (L)
To tighten:
Pull
VIDEO R AUDIO L
P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
1
2
2
Unplug the AC cord
Unplug the AC cord
pressing the two
knobs.
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet fi rst.
To loosen:
Push the catch
Pull
AUDIO
PC IN SERIAL
From EXTERNAL From SERIAL
monitor terminal Terminal on
on Computer Computer
(see page 10) (see page 11)
1
9