Pc Input Terminals Connection - Panasonic TH-37PH10UK Operating Instructions Manual

Connections

PC Input Terminals connection

Notes:
• Due to space limitations, occasionally you may have trouble connecting Mini D-sub 15P cable with ferrite core to PC
input Terminal.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 768 × 720 dots (TH-37PH10UK), 768 × 768 dots (TH-42PH10UK), 1,024 × 768
dots (TH-50PH10UK, TH-58PH10UK) when the aspect mode is set to "NORMAL", and 1,024 × 720 dots (TH-37PH10UK),
1,024 × 768 dots (TH-42PH10UK), 1,366 × 768 dots (TH-50PH10UK, TH-58PH10UK) when the aspect mode is set
to "FULL". If the display resolution exceeds these maximums, it may not be possible to show fi ne detail with suffi cient
clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will need
to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the D-sub 15P Connector.
• Change the "COMPONENT/RGB-IN SELECT" setting in the "SET UP" menu to "COMPONENT"
(when component connection) or "RGB" (when RGB signal connection). (see page 36)
Signal Names for Mini D-sub 15P Connector
TH-37PH10UK
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
TH-42PH10UK, TH-50PH10UK,
TH-58PH10UK
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Layout for PC Input
Terminal
10
COMPUTER
Conversion adapter
(if necessary)
Connect a cable which matches
the audio output terminal on the computer.
Pin No. Signal Name
R (P /C
1
R
G (Y)
2
B (P /C
3
B
NC (not connected)
4
GND (Ground)
5
TH-42PS9
RGB
PC cable
Audio
Pin No. Signal Name
) GND (Ground)
6
R
GND (Ground)
7
) GND (Ground)
8
B
NC (not connected)
9
GND (Ground)
10
(Example: TH-42PH10UK)
AUDIO
PC IN
Mini D-sub 15p
Stereo plug
Pin No. Signal Name
NC (not connected)
11
12
HD/SYNC
13
14
15
SDA
VD
SCL