Panasonic TH-37PH10UK Operating Instructions Manual page 34

SET UP for MULTI DISPLAY
6
7
Display Number locations for each arrangement.
(Examples)
( 2 × 1)
8
POWER ON SCREEN DELAY
Turning the power on for the multiple displays system, each display is turned on with a time lag to reduce the power
load.
Notes:
• This setting is valid when MULTI DISPLAY SETUP is ON.
• During this function is working, the power indicator is blinking green.
• This function also works when the power recovers from failure or after plugging off and in again the power cord.
If unplugging and plugging the power cord while the unit is in standby mode and the power is being supplied to the board,
each unit has time delay to start supplying the power to the attached board according to LOCATION, and the power
indicator lights up red fi rst and it turns orange when the power starts being supplied to the board.
9
34
Press to select SEAM HIDES VIDEO.
Press to select "OFF", "ON".
Press to select LOCATION.
Press to select the required arrangement number.
(A1-D4 : Refer to the following)
( 2 × 3 )
( 4 × 2 )
Press to select POWER ON SCREEN DELAY.
Press to select OFF or ON.
OFF: All the display turns on simultaneously.
ON: Each display turns on in the order of LOCATION.
Delay time=LOCATION (difference from A1) × 1 sec.
Example) Case of B2 in 4 × 2
Press twice to exit from SET UP.
MULTI DISPLAY SETUP
MULTI DISPLAY SETUP
HORIZONTAL SCALE
VERTICAL SCALE
SEAM HIDES VIDEO
LOCATION
POWER ON SCREEN DELAY
MULTI DISPLAY SETUP
MULTI DISPLAY SETUP
HORIZONTAL SCALE
VERTICAL SCALE
SEAM HIDES VIDEO
LOCATION
POWER ON SCREEN DELAY
( 4 × 4 )
MULTI DISPLAY SETUP
MULTI DISPLAY SETUP
HORIZONTAL SCALE
VERTICAL SCALE
SEAM HIDES VIDEO
LOCATION
POWER ON SCREEN DELAY
A1, A2, A3, A4, B1, B2
OFF
× 2
× 2
OFF
A1
ON
ON
× 2
× 2
OFF
A1
ON
ON
× 2
× 2
OFF
A1
ON
5 sec.