Connections - Panasonic TH-37PWD8GK Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
(Example: TH-42PWD8GK)
Speakers (Optional accessories)
SPEAKERS
Terminals (R)
– AC cord fi xing
1. Open the clamper.
Clamper
Note: The power plug in the illustration may not be the type fi tted to your set.
– Cable fi xing bands
Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
1
SLOT1
Note:
TH-37PWD8GK/S, TH-37PHD8GK/S have two slots only.
AC cord connection (see page 12)
2. I n s e r t t h e A C c o r d
and close the clamper
securely.
AC cord
To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
SLOT2
Optional Terminal
Board Insert Slot
(covered)
SPEAKERS
Terminals (L)
3. Slide up the clamper and fi x
the AC cord plug securely.
When loosen
the clamper:
To loosen:
To tighten:
Push the catch
Pull
SLOT3
From EXTERNAL
monitor terminal on
Computer (see page 10)
1
2
2
4. Insert the point of the
fi xed clamper into the
small hole on the lower
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on Computer
(see page 11)
1
r i g h t o f
t h e b a c k
c o v e r a s
necessary.
9