Denon AVR-3803 Operating Instruction page 37

Tone control setting
• Use the tone control setting to adjust the bass and treble as desired.
• To operate the tone control from the remote control unit.
1
Display the surround parameter
screen on the monitor.
The screen for the selected
surround mode appears.
"TONE" cannot be selected
(Remote control unit)
in the Direct mode.
2
Select "TONE".
(Remote control unit)
3
Switch to the Tone Control
screen.
Select Tone Defeat "OFF".
(Remote control unit)
4
To select Bass or Treble.
(Remote control unit)
5
Enter the setting.
The surround menu screen reappears.
(Remote control unit)
6
To end the setting mode, press the surround parameter button again.
(Remote control unit)
1, 6
2, 3, 4
5
To set the level.
(Remote control unit)
• To operate the tone control from the main unit.
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
BASS TREBLE
0 1
(Main unit)
2
With the name of the volume to be adjusted selected, turn the SELECT knob to adjust
SELECT
the level.
• To increase the bass or treble:
Turn the control clockwise. (The bass or treble sound can be increased to up to +10 dB in
steps of 2 dB.)
(Main unit)
• To decrease the bass or treble:
Turn the control clockwise. (The bass or treble sound can be decreased up to –10 dB in
steps of 2 dB.)
Surround parameters e
MODE: (DTS NEO:6)
• Cinema
This mode is optimum for playing movies.
performance to achieve the same atmosphere with 2-channel sources as with 6.1-channel sources.
This mode is effective for playing sources recorded in conventional surround formats as well, because the
in-phase component is assigned mainly to the center channel (C) and the reversed phase component to
the surround (SL, SR and SB channels).
• Music
This mode is suited mainly for playing music. The front channel (FL and FR) signals bypass the decoder
and are played directly so there is no loss of sound quality, and the effect of the surround signals output
from the center (C) and surround (SL, SR and SB) channels add a natural sense of expansion to the sound
field.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: "small", "med.s" (medium-small), "medium", "med.l" (medium-large) and "large".
"small" recreates a small sound field, "large" a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 300 ms.
TONE CONTROL:
This can be set individually for the separate surround modes other than Direct.
However, the same contents are set for DOLBY/DTS modes.
2
Decoding is performed with emphasis on separation
ENGLISH
1
37