Cisco Catalyst 6500 Series Configuration Manual page 90

Configuring Resource Management
Table 5-1 Resource Names and Limits (continued)
Minimum and Maximum
Resource Name Number per Context
pdm 1 minimum
5 maximum concurrent
ssh 1 minimum
5 maximum concurrent
syslogs N/A
telnet 1 minimum
5 maximum concurrent
xlates N/A
For example, to set the default class limit for conns to 10 percent instead of unlimited, enter the
following commands:
FWSM(config)# class default
FWSM(config-class)# limit-resource conns 10%
All other resources remain at unlimited.
To add a class called gold with all resources set to 5 percent, except for fixups, with a setting of
10 percent, enter the following commands:
FWSM(config)# class gold
FWSM(config-class)# limit-resource all 5%
FWSM(config-class)# limit-resource fixups 10%
To add a class called silver with all resources set to 3 percent, except for syslogs, with a setting of 500
per second, enter the following commands:
FWSM(config)# class silver
FWSM(config-class)# limit-resource all 3%
FWSM(config-class)# limit-resource rate syslogs 500
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
5-16
Total Number for System
32 concurrent
100 concurrent
30,000 per second (rate)
100 concurrent
256 K concurrent
Chapter 5 Managing Security Contexts
Description
PDM management sessions.
PDM sessions use two HTTPS
Note
connections: one for monitoring that is
always present, and one for making
configuration changes that is present
only when you make changes. For
example, the system limit of 32 PDM
sessions represents a limit of 64 HTTPS
sessions.
SSH sessions.
System messages.
The FWSM can support 30,000
Note
messages per second for messages sent
to the FWSM terminal or buffer. If you
send messages to a syslog server, the
FWSM supports 25,000 per second.
Telnet sessions.
NAT translations.
OL-6392-01