Resetting The Fwsm In Cisco Ios Software; Resetting The Fwsm In Catalyst Operating System Software - Cisco Catalyst 6500 Series Configuration Manual

Managing the Firewall Services Module Boot Partitions
To reset the FWSM, see the section for your operating system:
•
•
To reload the FWSM when you are logged into the FWSM, enter reload or reboot. You cannot boot from
Note
a non-default boot partition with these commands.

Resetting the FWSM in Cisco IOS Software

To reset the FWSM from the switch CLI, enter the following command:
Router# hw-module module mod_num reset [cf: n ] [mem-test-full]
The cf:n argument is the partition, either 1 (maintenance), 4 (application), or 5 (application). If you do
not specify the partition, the default partition is used (typically cf:4).
The mem-test-full option runs a full memory test, which takes approximately 6 minutes.
This example shows how to reset the FWSM installed in slot 9. The default boot partition is used.
Router# hw-mod mod 9 reset
Proceed with reload of module? [confirm] y
% reset issued for module 9
Router#
00:26:55:%SNMP-5-MODULETRAP:Module 9 [Down] Trap
00:26:55:SP:The PC in slot 8 is shutting down. Please wait ...

Resetting the FWSM in Catalyst Operating System Software

To reset the FWSM from the switch CLI, enter the following command:
Console> (enable) reset mod_num [cf: n ]
where cf:n is the partition, either 1 (maintenance), 4 (application), or 5 (application). If you do not
specify the partition, the default partition is used (typically cf:4).
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
2-14
Resetting the FWSM in Cisco IOS Software, page 2-14
Resetting the FWSM in Catalyst Operating System Software, page 2-14
Chapter 2 Configuring the Switch for the Firewall Services Module
OL-6392-01