Table of Contents
Advertisement
II Normal Stereo Reproduction
Press STEREO/EFFECT to turn off the sound
effect for normal stereo reproduction.
Press STEREO/EFFECT again to turn the sound
effect back on.
BASIC PLAYBACK
STEREO
~
Front panel
or
t
STEREO
~
Remote control
: : : : : ·r
I::~ ~;I
I::·
r•
.....
:
I••• : ·.1
.
• 1f''"IB MAIN SP" on the SET MENU is set to "SMALL" and
"' 1E LFE/BASS OlIT" is set to "SW", or" 1E LFE/BASS
OUT" is set to "BOTH", the LFE signals \vill be output from
the subwoofer.
• If you turn off the sound effect while a Dolby Digital or DTS
signal is being output, the dynan1ic range of the signal is
auton1atically cOlnpressed and the sounds of the center and rear
speaker channels are mixed and output from the lnain speakers.
• The volun1e tllay be greatly reduced when you turn otf the
sound etTect or if you set "II D-RANGE" on the SET MENlT
to MIN. In this case turn on the sound etlect.
II Displaying the information about
the input source
You can display the infonnation such as the type, fonnat
and salnpling frequency of the signal input froln the
component connected to this unit during stereo
reproduction.
(While playing a source)
o
Press AMP to select the AMP mode.
~
Press
ViA
to display the information about
the input signal.
33
II Normal Stereo Reproduction
Press STEREO/EFFECT to turn off the sound
effect for normal stereo reproduction.
Press STEREO/EFFECT again to turn the sound
effect back on.
BASIC PLAYBACK
STEREO
~
Front panel
or
t
STEREO
~
Remote control
: : : : : ·r
I::~ ~;I
I::·
r•
.....
:
I••• : ·.1
.
• 1f''"IB MAIN SP" on the SET MENU is set to "SMALL" and
"' 1E LFE/BASS OlIT" is set to "SW", or" 1E LFE/BASS
OUT" is set to "BOTH", the LFE signals \vill be output from
the subwoofer.
• If you turn off the sound effect while a Dolby Digital or DTS
signal is being output, the dynan1ic range of the signal is
auton1atically cOlnpressed and the sounds of the center and rear
speaker channels are mixed and output from the lnain speakers.
• The volun1e tllay be greatly reduced when you turn otf the
sound etTect or if you set "II D-RANGE" on the SET MENlT
to MIN. In this case turn on the sound etlect.
II Displaying the information about
the input source
You can display the infonnation such as the type, fonnat
and salnpling frequency of the signal input froln the
component connected to this unit during stereo
reproduction.
(While playing a source)
o
Press AMP to select the AMP mode.
~
Press
ViA
to display the information about
the input signal.
33
Advertisement
Table of Contents
