FujiFilm FinePix S3Pro Service Manual page 47

FinePix S3Pro Service Manual
Cautions When Adjusting
*1) FinePix S3Pro cannot adjust the EVR data reading
and writing.(Details are right tables.)
*2) End Setting returns the camera from the Jig mode to
the Product Mode.
End Setting is required when using the PC
adjustment software, even when replacing boards or
units other than those noted above. Failure to run
End Setting will prevent identification as Mass
Storage.
When the camera is connected to the PC, and
prevent communication with the PC.
*3) When all adjustment have been completed, always
check that the camera is identified as Mass Storage.
4. Adjustments
Menu Command
Operation Start
Stop
Temporary stop Temporary program stop
Step 0
End
Program Reload
Select
Edit
Data ad[ ]
rd[ ]
SW
fsw
EVR
Mode File record
NGSTOP
STEP
LINE
AUTO
Setting OKNG clear
Mode set
Automaticadjustment Execution setting for Auto
Help Help
FF help
Focus
Version
<Table> FFW.exe Commands
Details
Program start
Program stop
Do not use
Terminate program
Program (*.ff) reload
Program (*.ff) select
Program (*.ff) edit
Do not use
Do not use
Do not use
Do not use
Do not use *1)
Do not use
Program stopped if
adjustment is NG
Do not use
Do not use
Do not use
Do not use
Sets up mode
Adjust in user program
Basic software help
User program help
Not used with this
adjustment software
Version information for
basic software
47