Table of Contents
Advertisement
4. Adjustments
<Step 3>
Select the "EVR & Comm" tab ([1] in Fig. 4-6-3) in the
"Customize" dialog box that appears.
Set the "EVR" items ([2] in Fig. 8) as follows.
Item
etc (-V2)
Check
LANC page
Check
<Step 4>
Select the "Etc" tab ([1] in Fig. 4-6-4) in the "Customize"
dialog box that appears. Set the "Etc" items ([2] in Fig. 4-6-4)
as follows.
Item
# of auto measure (-In) 0
Change mode (-U)
Do not check
Use Japanese font
Do not check
(Valid after re-started)
Don't show OK NG Check or Do not check
<Step 5>
Select the "Hardware" tab ([1] in Fig. 4-6-5) in the
"Customize" dialog box that appears.
Input the values for PI/O port and P Board ([2] in Fig. 4-6-5).
PIO 0
10
PIO 1
11
Set the "Hardware" items ([3] in Fig. 4-6-5) as follows.
Item
Debug Mode
Select [Default]
<Step 6>
Once the above settings have been made, click on "Apply"
([4] in Fig. 4-6-5) in the "Customize" dialog box to complete
setup.
This applies the setup, therefore setting is unnecessary from
the next time forward.
[Note]
If [Disable OKNG display] on the PC screen (Fig. 4-6-4) is
set to OFF, the PC screen displays [OK] if adjustment is
OK,and [NG] if adjustment is NG(either setting is OK).
46
Details
Details
12
14
16
13
15
17
Details
FinePix S3Pro Service Manual
(2)
(1)
<Fig. 4-6-3>
(2)
<Fig. 4-6-4>
(1)
<Fig. 4-6-5>
(1)
(2)
(3)
(4)
Hide quick links:
Advertisement
Table of Contents
