Table of Contents
Advertisement
Using M5170
Use
On
Off
4
Click Submit.
Using Hibernate mode
Hibernate is an ultra‑low‑power operating mode.
Notes:
•
Three days is the default amount of time before the printer enters Hibernate mode.
•
Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long press of
the Sleep button wakes the printer from Hibernate mode.
•
If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1
From the home screen, navigate to:
> Settings > General Settings
2
From the "Press Sleep Button" or "Press and Hold Sleep Button" menu, select Hibernate, and then touch Submit.
Restoring factory default settings
If you want to keep a list of the current menu settings for reference, then print a menu settings page before restoring
the factory default settings. For more information, see
If you want a more comprehensive method of restoring the printer factory default settings, then perform the Wipe All
Settings option. For more information, see
Warning—Potential Damage: Restoring factory defaults returns most printer settings to the original factory default
settings. Exceptions include the display language, custom sizes and messages, and network/port menu settings. All
downloads stored in the RAM are deleted. Downloads stored in the flash memory or in a printer hard disk are not
affected.
From the home screen, navigate to:
> Settings > General Settings > Factory Defaults > Restore Now > Submit
To
Reduce printer noise.
Notes:
•
Print jobs process at a reduced speed.
•
Printer engine motors do not start until a document
is ready to print. There is a short delay before the
first page is printed.
•
The alarm control and cartridge alarm sounds are
turned off.
•
The printer will ignore the Advance Start command.
Use factory default settings.
Note: This setting supports the performance
specifications of the printer.
"Printing a menu settings page" on page
"Erasing non‑volatile memory" on page
123.
128.
126
Advertisement
Table of Contents
