Additional Safety Rules; Personal Protective Equipment; Protection Against Electric Shock; Safe Working Practices - Makita UC3020A Instruction Manual

006908
− Do not overreach and do not cut above
shoulder
unintended tip contact and enables better
control of the chain saw in unexpected
situations.
− Only use replacement bars and chains
specified by the manufacturer. Incorrect
replacement bars and chains may cause
chain breakage and/or kickback.
− Follow the manufacturer's sharpening
and maintenance instructions for the saw
chain. Decreasing the depth gauge height
can lead to increased kickback.

ADDITIONAL SAFETY RULES

1. Read the instruction manual in order to familiarize
yourself with operation of the chain saw.
2. Before using the chain saw for the first time,
arrange to have instruction in its operation. If this
is not possible, at least practice cutting round
timber on a trestle before beginning work.
3. The chain saw must not be used by children or
young persons under 18 years of age. Young
persons over 16 years of age may be exempted
from this restriction if they are undergoing training
under the supervision of an expert.
4. Working with the chain saw requires a high level
of concentration. Do not work with the saw if you
are not feeling fit and well. Carry out all work
calmly and carefully.
5. Never work under the influence of alcohol, drugs
or medication.
Proper use
1. The chain saw is intended solely for cutting wood.
Do not use it for example to cut plastic or porous
concrete.
2. Only use the chain saw for operations described
in this instruction manual. Do not, for example,
use it to trim hedges or for similar purposes.
3. The chain saw must not be used for forestry work,
i.e. for felling and limbing standing timber. The
chain saw cable does not provide the operator
with the mobility and safety required for such
work.
4. The chain saw is not intended for commercial use.
5. Do not overload the chain saw.
height. This helps

Personal protective equipment

1. Clothing must be close-fitting, but must not
obstruct mobility.
2. Wear the following protective clothing during
work:
A tested safety helmet, if a hazard is
•
presented by falling branches or similar;
A face mask or goggles;
•
Suitable ear protection (ear muffs, custom or
•
mouldable ear plugs). Octave brand analysis
prevent
upon request.
Firm leather safety gloves;
•
Long trousers manufactured from strong
•
fabric;
Protective dungarees of cut-resistant fabric;
•
Safety shoes or boots with non-slip soles,
•
steel toes, and cut-resistant fabric lining;
A breathing mask, when carrying out work
•
which produces dust (e.g. sawing dry wood).

Protection against electric shock

1. Only plug the saw into sockets in tested electrical
circuits. Check that the system voltage matches
that on the rating plate. Ensure that a 16 A line
fuse is fitted. Saws used in the open air must be
connected to a residual current-operated circuit-
breaker with an operating current no higher than
30 mA.

Safe working practices

1. Before starting work, check that the chain saw is
in proper working order and that its condition
complies with the safety regulations. Check in
particular that:
The chain brake is working properly;
•
The run-down brake is working properly;
•
The bar and the sprocket cover are fitted
•
correctly;
The chain has been sharpened and tensioned
•
in accordance with the regulations;
The mains cable and mains plug are
•
undamaged;
Refer to the "CHECKS " section.
2. Always ensure in particular that the extension
cable used is of adequate cross-section (see
"SPECIFICATIONS"). When using a cable reel,
wind the cable completely off the reel. When
using the saw in the open air, ensure that the
cable employed is intended for open-air use and
is rated accordingly.
8
･
The chain saw must not be used in wet
weather or damp environments, as the
electric motor is not waterproof.
･
Should the connecting
damaged, withdraw the mains plug
immediately.
cable be