Figure 3. Connect Equipment For Bandwidth Test - Agilent Technologies 5000 Series Service Manual

Power Splitter
Power Sensor
5000 Series Oscilloscopes Service Guide
1 Connect the equipment (see
a Use the N cable to connect the signal generator to the
input of the power splitter input.
b Connect the power sensor to one output of the power
splitter.
c Use an N-to-BNC adapter to connect the other splitter
output to the channel 1 input.
Oscilloscope
N to BNC adapter
Power Meter
Figure 3 Connect equipment for bandwidth test
2 Set up the power meter.
Set the power meter to display measurements in units of
watts.
Testing Performance
Figure 3).
Signal
Generator
N Cable
2
29