Panasonic Diga DMR-E80H Operating Instructions Manual page 57

Sound
No sound.
Low volume.
Distorted sound.
Cannot hear the desired
audio type.
Cannot switch audio during
stereo or SAP broadcasts.
Play
Play fails to start even when
[1] (PLAY) is pressed.
Play starts but then stops
immediately.
A title or chapter doesn't play
when it is selected.
Picture distorted during
search.
Alternative soundtrack and
subtitles cannot be selected.
No subtitles.
Angle cannot be changed.
You have forgotten your rat-
ings password.
Displays
The display is dim.
"12:00" is flashing on the
unit's display.
The displayed recording time
and actual recording time dif-
fer.
The display doesn't show the
correct time. [MP3]
Remote control
The remote control doesn't
work.
Cannot operate the televi-
sion.
≥Check the connections. Check the input mode on the amplifier if you have connected one.
≥Turn V.S.S. off if it causes distortion.
≥Press [AUDIO] to select the desired audio type.
≥If "D.MIX" does not appear in the display when playing multi-channel DVD-Audio, audio output
will be the front two speakers only.
≥You cannot change the DVD-Audio audio type if the software producer has restricted play in
stereo.
≥You have used digital connection. Set "Dolby Digital" to "PCM" or connect to other equipment
using audio cables (analog connection).
≥You cannot change the audio type when a DVD-R is in the disc tray.
≥It is not possible to switch the audio when the recording mode is XP and "LPCM" has been
selected in the SETUP menu, "Audio Mode for XP Recording".
‹ Select "Main" or "SAP" from "Select MTS" in the Audio menu before recording.
≥Insert the disc correctly with the label facing up.
≥This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Audio, DVD-Video, Video CD,
CD and MP3 discs.
≥The disc is dirty. Clean it.
≥The disc may be badly scratched.
≥You inserted a blank DVD-RAM or DVD-R.
≥Some titles and chapters on DVD-Video are not played when you have changed the ratings
level.
≥Some distortion is normal.
≥The languages are not recorded on the disc.
≥You may have to use the disc's menus to select languages.
≥Subtitles are not recorded on the disc.
≥Turn the subtitles on.
≥This function depends on software availability. Angles can only be changed during scenes
where different angles are recorded.
≥Return the ratings setting to "8".
While the disc tray is open, press and hold [:/6] and [5/9] on the main unit at the
same time for 5 or more seconds.
≥Go to the Display menu and change the display's brightness with "FL Display".
≥The clock is not set.
≥Displayed recording time is based on the number of frames per second. This number is sub-
ject to minute variations. When recording over long periods, these variations may result in the
difference between displayed recording time and actual recording time. This is normal.
≥Times may not appear correctly when searching through tracks recorded with a variable bit
rate.
≥[DVD, TV] is not switched to "DVD". Switch to "DVD" when operating this unit.
≥The remote control and main unit are using different codes. Change the code on the remote
control or main unit.
≥The batteries are depleted. Replace them with new ones.
≥Point the remote control at the remote control sensor on the main unit.
≥Remove obstacles from between the remote control and main unit.
≥Change manufacturer code. Some televisions cannot be operated even if you change the
code.
≥[DVD, TV] is not switched to "TV". Switch to "TV" when selecting the receiving channel for the
television.
Page
5,
50–52
41
39
13
—
45, 51
—
45
14
10
54
—
—
44
—
—
19
—
40
—
—
45
47
—
—
12
46
6
6
—
9
12
57
RQT6984