The Remote Control; Batteries; Use; Television Operation - Panasonic Diga DMR-E51 Operating Instructions Manual

Batteries

≥Insert so the poles (- and +) match those in the remote control.
≥Do not use rechargeable type batteries.
Do not;
≥mix old and new batteries
≥use different types at the same time
≥heat or expose to flame
≥take apart or short circuit
≥attempt to recharge alkaline or manganese batteries
≥use batteries if the covering has been peeled off
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
If electrolyte leaks from the batteries, consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with any
part of your body.
Remove if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
Replace if the unit does not respond to the remote control even
when held close to the front panel.

Use

Aim at the sensor, avoiding obstacles, at a maximum range of 7 m
directly in front of the unit.
≥Keep the transmission window and the unit's sensor free from
dust.
≥Operation can be affected by strong light sources, such as direct
sunlight, and the glass doors on cabinets.
(1)
(2)
20
20
30
30
DVD TV
(3)
(1) Remote control signal sensor
(2) 7 m directly in front of the unit.
(3) Switch [DVD, TV] (15) to "DVD".
Do not;
≥put heavy objects on the remote control
≥take the remote control apart
≥spill liquids onto the remote control

The remote control

Television operation

You can control televisions by changing the remote control code.
Preparation
≥Turn on the television.
≥Switch [DVD, TV] (15) to "TV".
R6, AA, UM-3
1
2
Notes
≥If there is more than one code, repeat the procedure until you find
≥Repeat this procedure after you change the batteries.
≥If your television brand is not listed or if the code listed for your
List of TVs Compatible with the unit's Remote Control
Brand:
Panasonic/National
SONY
TOSHIBA
JVC
HITACHI
MITSUBISHI
SHARP
PHILIPS, SAMSUNG
NEC
SANYO
GOLDSTAR/LG
SAMSUNG
SANYO
Operation:
On and off:
Video input mode:
Channels:
Volume:
Numeric:
7
Refer to the chart below for the code for your
television.
Press and hold [TV, Í] (14) and enter the two-digit
code with the numeric buttons (4).
≥For example: 01, press [0] )[1].
≥After entering the code, test the remote control by turning on
the television and changing channels.
the code that allows correct operation.
television does not allow control of your television, this remote is
not compatible with your television.
Code
01, 02, 03, 04
05
06
07
08
09, 10
11
12
13
14
15, 16
17, 18
19
Button
[TV, Í] (14)
[AV] (3)
[W, X, CH] (18)
[i, j, VOLUME] (19)
[0-9, -/--] (4)