Error Displays - Panasonic Diga DMR-E51 Operating Instructions Manual

Error messages
No Disc.
This is a non-recordable disc.
Cannot record.
This disc is not properly formatted.
Formatting is necessary using DISC
INFORMATION.
This disc cannot be read.
Please check write protect tab on the
disc.
Contents of this disc are protected.
Cannot finish recording completely.
Cannot record on the disc.
Cannot record to the disc.
TV system of input signal is different to
the setting in SETUP.
Disc is full.
Please set clock.
This disc may not be played in your
region.
Your selection exceeds the recorder's
rating limit.
Error has occurred.
Please press ENTER.
Please check the disc.
Please change the disc.
Finalizing is necessary for compatible
playback.
Please check write protect tab.

Error displays

Causes and solutions
≥You haven't inserted a disc. Correctly insert a disc that this unit can play. (page 13)
≥The disc is upside down. If it is a single-sided disc, insert it so the label is facing up.
(page 13)
≥The unit cannot record on the disc you inserted. The unit cannot record onto finalized
DVD-R, DVD-Video, CDs or Video CDs.
Insert a DVD-RAM or unfinalized DVD-R. (page 8)
≥You inserted an unformatted DVD-RAM.
Format the disc with this unit. (page 31)
≥You inserted an incompatible disc. (page 13)
≥The write protect tab on the cartridge is set to
"PROTECT".
Use a ballpoint pen or similar to release the
write protection.
≥The programme is write-protected.
Release the protection with the direct navigator. (page 35)
≥The disc is write-protected.
Release the protection with the disc protection sub menu of DISC INFORMATION.
(page 30)
≥The programme was copy-protected.
≥TV system of the programme was different from the setting in SETUP, so the timer
recorded was not completed.
≥The disc is full.
≥Recording was not completed for some other reason.
≥The disc is scratched. Use another disc.
≥The disc is dirty. Clean the disc as described in these operating instructions. (page 60)
≥TV system of the programme or the input signal was different from the setting in SETUP.
≥No space left on the disc.
Create space by erasing any unwanted programmes. (page 34)
Use a new disc.
≥The clock is not set correctly. Reset the clock using "Clock Settings". (page 56)
≥You tried to play a disc with a region number different from this unit's region number.
This unit can play only play discs with the region numbers compatible with this unit.
(page 8)
≥A ratings level has been set for DVD-Video with this unit. Temporarily unlock the unit
with "Ratings" in the disc menu. (page 54)
≥You can operate the unit using the [ENTER] (10) only.
≥After you press the [ENTER] (10), turn off the unit and then turn it on. Recovery starts.
≥Check the discs for dirt or scratches. (page 60)
≥You can operate the unit using the [<, OPEN/CLOSE] (27) only.
≥Press [<, OPEN/CLOSE] (27) to open the tray and eject a disc, the unit becomes off.
≥To continue play or recording, insert an another disc.
≥To enable playback of your DVD-R on compatible equipment, it is necessary to finalize
it. (page 32)
≥Release the protection on the DVD-RAM.
64
PROTECT