Edimax BR-6478 AC V2 User Manual page 166

4. I can't access the Internet.
a. Ensure that all cables are connected properly. Try a different Ethernet cable.
b. Check if you can access the web based configuration interface. If not, please
ensure your computer is set to use a dynamic IP address.
c. Login to the web based configuration interface and go to Internet > WAN Setup
and check that the connection type is correct. If you are unsure which internet
connection type you have, please contact your Internet Service Provider (ISP).
d. Connect your computer directly to your modem and check if you can access the
internet. If you can't, please contact your Internet service provider for
assistance.
5. I can't open the web based configuration interface.
a. Please ensure your computer is set to use a dynamic IP address.
6. How do I reset my device to factory default settings?
a. To reset the device back to its factory default settings, press and hold the
WPS/Reset button for over 10 seconds, until the Internet LED begins to flash.
Please wait a few minutes for the product to restart. When the device restarts,
all settings will be reset. Default settings are displayed on the product label on
the back of the device, as shown below:
Router Login Enter this URL in a web browser to run iQ Setup or
configure advanced settings. You must be
162