Taking Pictures Using Burst Mode - Panasonic Lumix DMC-LC50GN Operating Instructions Manual

Taking Pictures using Burst Mode

Preparation
• Set the mode dial except for [
1
Switch the burst mode setting.
H
: High speed
H
;
: Low speed
L
;
No display (cancelled)
2
Take pictures.
• Keep pressing the shutter button
fully to activate the burst mode.
¬ Suggestions/Tips ¬
• If the flash is activated, you can record
only 1 picture.
• In Simple mode [
is fixed to Low. (P29)
• You cannot take pictures with audio in
the burst mode.
• When setting auto bracket and the
burst mode simultaneously, auto
bracket will be performed.
• Burst mode will not perform as
described if a MultiMediaCard is used
in place of an SD Memory Card. The
reading/writing speed of a
MultiMediaCard is slower than that of
an SD Memory Card.
Recording pictures (basic)
]/[
1600
19
], the burst speed
39
]. (P8)
• In the following cases, the burst speed
becomes slow due to the signal
processing, however, this is not a
malfunction.
(a) When the shutter speed becomes
slow because you take pictures in
dark places.
(b) When you use the camera in high
temperature.
The number of pictures taken at a time
is not limited in the above cases.
• When the ISO sensitivity is set to
[ISO400], you cannot use the burst
mode. (DMC-LC80)
ª Number of pictures recorded in
burst mode
Burst speed
(pictures/
second)
H
DMC- 2.7
°1
LC80 ( )
DMC- 3.3
°1
LC70 ( )
DMC- 3.5
°1
LC50 ( )
°1 When the shutter speed is faster
than 1/60 and the flash is not
activate.
°2 2304k1728 picture size
°3 2048k1536 picture size
Number of
recordable
pictures (pictures)
L
1.5 max. 5 max. 9
max. 3 max. 5
°2 °2
/
2 ( ) ( ) /
max. 5 max. 10
max. 8
°3
2 max. 5 ( ) /
max. 10