Table of Contents
Advertisement
You can fix the flash slanting at an angle
of about 65o as follows in bounce flash.
(Bounce flash lock)
Aim the flash to the ceiling and take
the picture.
• We recommend setting the white
balance to [AUTO] (P61).
¬ Suggestions/Tips ¬
• In Motion image mode or when the
flash is closed, flash setting is fixed to
the Forced OFF [
• Do not stare at the photo flash from
close proximity when using the
flash.
• If you bring the flash too close to
the subjects, they may be distorted
or discoloured by its heat and
lighting.
• Do not cover the photo flash with
your fingers or any other items.
• When you take pictures out of the
range of the flash control, the picture
may be over exposed.
• When the jitter alert appears, we
recommend using the flash.
• When you set to burst mode or auto
bracket, only 1 picture is recorded for
every flash activated.
Recording pictures (basic)
• The flash icon turns red when
• When the flash is being charged, the
• When taking a picture with the
• When taking a picture with the flash,
• When the shutter speed is fast, the
• To avoid noises, we recommend
• Refer to P68 for the ISO sensitivity.
• Refer to P105 for the external flash.
• In the bounce flash
].
• When you repeat taking pictures using
46
activating the flash and pressing the
shutter button halfway.
flash icon blinks red, and you cannot
take a picture even when you press
the shutter button fully.
flash, we recommend removing the
lens hood. In some cases it may not
allow the scene to be illuminated
properly.
the white balance will be automatically
adjusted [except for [
WB
and [
] (Flash)] (P61), but the white
balance may not be properly adjusted
when the photo flash is insufficient.
flash effect may not be sufficient.
setting each item on [PICT.ADJ.] to
[LOW]. (P72)
• Select the whitish ceiling with high
reflection ratio. If not, the colour or
the pattern may be reflected to the
picture.
• The available flash range becomes
shorter than usual.
• When you select too high ceiling,
the reflected light may not reach to
the subject.
• Using the flash for bounce flash on
the position other than specified
may cause a malfunction.
the flash, recording may be impossible
if the flash is activated. Try recording
after the card access indicator turns
off.
] (Daylight)
Advertisement
Table of Contents
