Message Display - Panasonic Lumix DMC-LC1GN Operating Instructions Manual

Message Display

[NO MEMORY CARD]
Insert the card.
[THIS MEMORY CARD IS
PROTECTED]
Cancel the card lock.
[NO VALID IMAGE TO PLAY]
Play back after recording or after
inserting the card with a recorded
picture.
[MEMORY CARD FULL] /
[NOT ENOUGH MEMORY IN THE
CARD]
Insert a new card or delete the
unnecessary data.
[PLEASE CLOSE THE FLASH]
Be sure to close the flash after use.
[MEMORY CARD DOOR OPEN]
Close the card door.
[PLEASE SET THE CLOCK]
This message appears when you use
the camera for the first time or you do
not use the camera for a long time.
Set the clock.
[THIS PICTURE IS PROTECTED]
After cancelling the protect setting, you
can delete or overwrite the picture.
[THIS PICTURE CAN'T BE
DELETED] / [SOME PICTURES CAN'T
BE DELETED]
The pictures not based on the DCF
standard cannot be deleted.
[CAN'T BE SET ON THIS PICTURE] /
[CAN'T BE SET ON SOME
PICTURES]
If the pictures are not based on the DCF
standard, the DPOF print cannot be set.
Others
[NO ADDITIONAL DELETE
SELECTIONS CAN BE MADE]
You have exceeded the number of
pictures that can be set at once with
multi-delete setting.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The format of the card cannot be
recognized by this camera. Format the
card again with this camera.
[SYSTEM ERROR]
This message appears when a
malfunction occurs on the operation of
the lens. Turn the camera off and on. If
the message persists, contact the
dealer or your nearest servicentre.
[MEMORY CARD ERROR]
(It may take time to display this
message depending on the card.)
Failed access to the card.
Insert the card again.
[READ ERROR]
Data reading error.
Play it back again.
[WRITE ERROR]
Data writing error.
Turn the camera off and remove the
card. Then insert the card and turn the
camera on again. Be sure that the
camera is turned off before removing or
inserting the card to avoid damage.
[PLEASE WAIT]
This message appears when shutter
speed is slow or the camera becomes
warm.
120