Connecting To A Pictbridge-Compliant Printer - Panasonic Lumix DMC-FZ5GN Operating Instructions Manual

Connecting to a PictBridge-compliant Printer

By connecting the camera directly to a
printer supporting PictBridge via the USB
connection cable (supplied), you can select
the pictures to be printed or start printing
on the LCD monitor.
Set the print settings such as print quality
on the printer beforehand. (Read the printer
operating instructions.)
A: USB connection cable (supplied)
B: AC adaptor (DMW-CAC1; optional)
1 Turn the camera on and then set
[USB MODE] on the [SETUP]
menu to [PictBridge (PTP)]. (P95)
2 Turn on the printer.
3 Connect the camera to a printer
via the USB connection cable A
(supplied).
98
VQT0Q40
Connecting to a PC or Printer
• Connect the USB connection cable with
the [
• Hold the plug C to push into or pull out.
When the DPOF
Print is not set.
When the DPOF
Print is set. (P85)
• It may take time to print some pictures.
Therefore, use a battery with sufficient
battery power (P13) or the AC adaptor
(DMW-CAC1; optional) when you connect
to a printer.
• If the remaining battery power becomes
low during communication, the power
indicator blinks and the alarm beeps. In
this case, stop the communication at
once.
• Disconnect the USB connection cable
after printing.
AV OUT/ • Do not use any other USB connection
DIGITAL
cables except the supplied one.
DC IN 8.4V
] mark facing you.
Select [SINGLE
PICTURE]. (P99)
Select [DPOF
PICTURE]. (P100)