Verifying Package Contents - Cisco IE 2000 Installation Manual


For 10/100 ports and 10/100/1000 ports, the cable length from a switch to an attached device cannot exceed 328
feet (100 meters).

For 100BASE-FX fiber-optic ports, the cable length from a switch to an attached device cannot exceed 6562 ft (2
km).

Operating environment is within the ranges listed in

Clearance to front and rear panels meets these conditions:
— Front-panel LEDs can be easily read.
— Access to ports is sufficient for unrestricted cabling.
— Front-panel direct current (DC) power connectors and the alarm connector are within reach of the connection
to the DC power source.

Airflow around the switch must be unrestricted. To prevent the switch from overheating, you must have the following
minimum clearances:
— Top and bottom: 2.0 in. (50.8 mm)
— Sides: 2.0 in. (50.8 mm)
— Front: 2.0 in. (50.8 mm)

Temperature surrounding the unit does not exceed 140°F (60°C).
Note: When the switch is installed in an industrial enclosure, the temperature within the enclosure is greater than
normal room temperature outside the enclosure.
Note: The temperature inside the enclosure cannot exceed 140°F (60°C), the maximum ambient enclosure
temperature of the switch.

Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting fixtures.

Connect the unit only to a Class 2 DC power source.

Verifying Package Contents

The Cisco IE 2000 Switch Getting Started Guide on Cisco.com describes the box contents. If any item is missing or
damaged, contact your Cisco representative or reseller for support.
Installing or Removing the Flash Memory Card (Optional)
The software /firmware is stored on the internal flash memory in the Cisco IE2000 switch. Optionally, you can order and
install an SD memory card (SD-IE-1GB=) to store the software and the configuration changes. If you need to replace the
switch, you can simply insert the SD memory card instead of configuring the new switch.
Warning: Do not insert or remove the flash card while power is on; an electrical arc can occur. This could cause an
explosion in hazardous location installations. Be sure that power is removed or the area is nonhazardous before
proceeding. Statement 379
To install or replace the flash memory card, follow these steps:
1. On the front of the switch, locate the door that protects the flash memory card slot. Loosen the captive screw at the
top of the door using a Phillips screwdriver to open the door. See
Technical Specifications, page 79
Figure 12 on page
31
32.