Using The Hose And Tools - Vax VCW-06 User Manual

OPERATING THE MACHINE
! !

Using the hose and tools

! !
CAUTION: Always unplug the carpet washer before connecting or disconnecting the hose and tools.
! !
Use extra caution when cleaning stairs to prevent the carpet washer from tipping or falling over.
Do not leave the carpet washer on or at the top of the stairs while cleaning.
! !
CAUTION: Always check the cleaning code on your upholstery. The carpet washer should only
be used on upholstery marked 'W' or 'W/S'. Check with the upholstery manufacturer before use.
Run the wash tool over a small hidden area to test before cleaning.
Pull open the hose
connector cover.
Plug into the mains and press
the on/off switch to turn
the machine on. Handle must
be in upright position when
using tools. (Upright handle
position turns brushbar off to
prevent carpet damage).
10
Push the hose connector into
the hose connector port.
1
Press the trigger on the hose
to release a clean water/solution
mix. Squeeze the trigger on
the forward stroke to release
water and solution to clean
carpets/upholstery.
Slide the SpinScrub™ or
upholstery wash tool over the tab
at the end of the hose until
it clicks into place.
2
Release the trigger on the
backward stroke to pick
up dirty water. Repeat the
process for cleaning tough stains.
vaxcommercial.co.uk