Table of Contents
Advertisement
Let's talk technical
Removing a blockage from the hose
Remove hose end
from the floor head.
TIP: Test for blockages by dropping a small ball of paper through the those. Remove any blockage by inserting wire
coat hanger into hose.
Replacing the belt
Lie vacuum cleaner
on its back exposing
brush bars. Use a cross
head screwdriver.
Undo 5 screws
Place belt on rounded
area of brush bar
without bristles.
Lift clip under the
hose inlet.
Lift to remove
brush bar cover.
Line up right side of
brush bar with base,
push into place. Lift and
push left side of brush
bar until clicks into place.
Pull latch out and
remove hose.
Lift to remove brush
bar. Remove and
dispose of old belt.
Line up brush bar
cover, push until it
clicks into place.
Replace 5 screws
and tighten.
Line up latch, push until
it clicks into place.
Clean any debris from
spindle. Place new
belt on spindle.
Advertisement
Table of Contents
